KENNEDY SPACE CENTER, FLA. -- Workers perform post-polishing inspection on Atlantis' flow liners. Following an extensive investigation into the cause of tiny cracks inside fuel lines of the four space shuttle orbiters, a welding and polishing process is being implemented that will restore flow-liner integrity to design condition. These liners are inside the space shuttle Main Propulsion System fuel lines to preclude liquid hydrogen and oxygen turbulent flow into the engines during launch and climb to orbit. The technique calls for welds of three very small cracks on Atlantis and two on Endeavour. Additionally, the microscopic rough edges of the liner holes are being smoothed by polishing to reduce the chance of more cracks developing in the future. Atlantis is scheduled on mission STS-112, an assembly flight to the International Space Station, no earlier than Sept. 28, 2002. (Photo Release Date: 08/05/2002 )

KSC-02PD-1153 - Raw ASCII Text Caption file
KSC-02PD-1153 - Low (GIF Format, 320x240 pixels x 256 colors, approx 50 Kbytes)
KSC-02PD-1153 - Medium (JPEG format, 1024x768 pixels x 256 colors, approx 250 Kbytes)
KSC-02PD-1153 - High (JPEG, 2040x2640 pixels x 16 million colors, approx 400 Kbytes)

STS-112 KSC Photo IndexNext Image KSC-02PD-1154


DISCLAIMER: No copyright protection is asserted for these photographs.

If a recognizable person appears in this photograph, use for commercial purposes may infringe a right of privacy or publicity. It may not be used to state or imply the endorsement by NASA of a commercial product. These photographs are available for preview and download in electronic digital form ONLY. They may not be ordered from NASA in photograph form. (See NASA Copyright Notice)